Toughened safety glass in Portslade

Toughened safety glass in Portslade: what will it cost?

Expect £114 to £414 including VAT (£95 to £345 plus VAT) per pane for toughened safety glass in Portslade. The written quote names the glass makeup, the price and the lead time before you commit.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What you can specify

Breaks into small blunt fragments
Clear, tinted, obscure, low-iron and sandblasted finishes
Single panes or the outer pane of a sealed unit
Heat-soaked option for large and overhead panes
Made to BS EN 12150 and marked for identification
Made to measure for each opening

Fitting in Portslade and nearby

We arrange surveys and fitting in Portslade and across the BN41 postcode district, as well as in nearby Hove (2 miles) and Brighton (3 miles). Dates depend on installer availability.

East Sussex mixes the Regency bow-fronted terraces and busy shopping lanes of Brighton and Hove with Victorian seafronts in Eastbourne and Hastings and historic Lewes and Rye.

Typical settings for toughened safety glass:

Panes below 800 mm in homes and offices
Shower screens and splashbacks
Glazed doors and side panels
Frameless office partitions and doors

Getting the right glass for your building

Barriers and balustrades

Glass that acts as a barrier usually needs a laminated toughened makeup so it stays in place if one ply breaks.

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

What the rules say in England

England

Fire-rated glass is different

Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

How it works

Send sizes or use the quote tool
Free survey at your Portslade address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Portslade: questions

Do you cover Hove as well as Portslade?

Yes. As well as Portslade, we can arrange surveys in nearby Hove, Brighton and Worthing. Dates depend on installer availability.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Toughened safety glass in nearby towns

Other glazing in Portslade

Ready for a price? Use the form or call 0800 088 6248.