Toughened safety glass in Tyne and Wear

What is the price of toughened safety glass in Tyne and Wear?

Expect £114 to £414 including VAT (£95 to £345 plus VAT) per pane for toughened safety glass in Tyne and Wear. The written quote names the glass makeup, the price and the lead time before you commit.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

Choices you can make

Made to BS EN 12150 and marked for identification
Holes, notches and polished edges for frameless fittings
Four to five times the strength of annealed glass
Breaks into small blunt fragments
Single panes or the outer pane of a sealed unit
Heat-soaked option for large and overhead panes

Covering Tyne and Wear

We can arrange surveys and fitting anywhere in Tyne and Wear, including Newcastle upon Tyne and Sunderland. Dates depend on installer availability. Choose your town below for local details.

Tyne and Wear covers Newcastle's Grainger Town stone streets and quayside offices, the town centres of Sunderland and Gateshead, and large inter-war and post-war housing estates.

This glazing suits:

Glazed doors and side panels
Balustrades in a laminated toughened makeup
Shower screens and splashbacks
Frameless office partitions and doors

Towns in Tyne and Wear

Questions we will ask at the survey

Barriers and balustrades

Glass that acts as a barrier usually needs a laminated toughened makeup so it stays in place if one ply breaks.

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Building regulations and safety in England

England

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

How it works

Send sizes or use the quote tool
Free survey at your Tyne and Wear address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Tyne and Wear: questions

Which towns in Tyne and Wear do you cover?

We can arrange work anywhere in Tyne and Wear, including Newcastle upon Tyne, Sunderland, South Shields, Gateshead and Washington, and in other towns across the area.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

Is toughened glass a security glass?

No. Toughened glass is strong and breaks safely, but once broken the pane falls out and leaves the opening clear. For security, choose laminated glass or a unit with a laminated pane.

Other glazing in Tyne and Wear

Ready for a price? Use the form or call 0800 088 6248.