Toughened safety glass in Whitley Bay

How much should I budget for toughened safety glass in Whitley Bay?

Our guide range for toughened safety glass in Whitley Bay is £114 to £414 including VAT (£95 to £345 plus VAT) per pane, including fitting. The survey is free for new installations and your fixed price follows in writing.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What goes into toughened safety glass

Clear, tinted, obscure, low-iron and sandblasted finishes
Heat-soaked option for large and overhead panes
Holes, notches and polished edges for frameless fittings
Four to five times the strength of annealed glass
Breaks into small blunt fragments
Single panes or the outer pane of a sealed unit

Fitting in Whitley Bay and nearby

Surveys in Whitley Bay (NE26) are booked around installer availability. We also cover nearby North Shields (2 miles), Tynemouth (2 miles) and South Shields (3 miles).

Tyne and Wear covers Newcastle's Grainger Town stone streets and quayside offices, the town centres of Sunderland and Gateshead, and large inter-war and post-war housing estates.

Common uses:

Frameless office partitions and doors
Shower screens and splashbacks
Panes below 800 mm in homes and offices
Balustrades in a laminated toughened makeup

What to think about first

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Consents and safety: England

England

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

Replacing glass in an existing frame

Replacing only the glass or sealed unit in an existing frame is generally treated as a repair in England rather than notifiable building work. Replacing a whole window or door is notifiable and is normally certified through a competent person scheme or approved by building control. Either way, new glass in a critical location should still be safety glass.

How it works

Send sizes or use the quote tool
Free survey at your Whitley Bay address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Whitley Bay: questions

Can you survey in Whitley Bay and nearby towns?

Yes. Surveys in Whitley Bay, North Shields and Tynemouth are booked around installer availability.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

Toughened safety glass in nearby towns

Other glazing in Whitley Bay

Ready for a price? Use the form or call 0800 088 6248.