Toughened safety glass in Hythe

What is the price of toughened safety glass in Hythe?

Typical prices for toughened safety glass in Hythe are £114 to £414 including VAT (£95 to £345 plus VAT) per pane, supplied and fitted. Use the quote tool for a guide figure, then we survey and confirm a fixed price.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What goes into toughened safety glass

Holes, notches and polished edges for frameless fittings
Single panes or the outer pane of a sealed unit
Made to measure for each opening
Made to BS EN 12150 and marked for identification
Clear, tinted, obscure, low-iron and sandblasted finishes
Breaks into small blunt fragments

Fitting in Hythe and nearby

Surveys in Hythe (SO45) are booked around installer availability. We also cover nearby Southampton (3 miles), Totton (6 miles) and Eastleigh (8 miles).

Hampshire covers the port-city shops and offices of Southampton and Portsmouth, Winchester's listed centre, and commuter estates around Basingstoke, Eastleigh and Fareham.

This glazing suits:

Frameless office partitions and doors
Balustrades in a laminated toughened makeup
Panes below 800 mm in homes and offices
Glazed doors and side panels

Questions we will ask at the survey

Heat soaking

Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.

Barriers and balustrades

Glass that acts as a barrier usually needs a laminated toughened makeup so it stays in place if one ply breaks.

Building regulations and safety in England

England

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

How it works

Guide price online or by phone
Survey in Hythe
Accept the fixed quote
Fitted by glaziers working under our contract

Toughened safety glass in Hythe: questions

Can you survey in Hythe and nearby towns?

Yes. Surveys in Hythe, Southampton and Totton are booked around installer availability.

Is toughened glass a security glass?

No. Toughened glass is strong and breaks safely, but once broken the pane falls out and leaves the opening clear. For security, choose laminated glass or a unit with a laminated pane.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

Toughened safety glass in nearby towns

Other glazing in Hythe

Tell us about the glazing and we will come back with a guide price.

Free quote in Hythe