Toughened safety glass in Southampton

How much should I budget for toughened safety glass in Southampton?

Guide prices for toughened safety glass in Southampton are £114 to £414 including VAT (£95 to £345 plus VAT) per pane for supply and fitting. We confirm a fixed price in writing after a free survey, before any glass is ordered.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What goes into toughened safety glass

Made to measure for each opening
Four to five times the strength of annealed glass
Made to BS EN 12150 and marked for identification
Heat-soaked option for large and overhead panes
Breaks into small blunt fragments
Clear, tinted, obscure, low-iron and sandblasted finishes

Fitting in Southampton and nearby

Surveys in Southampton (SO15) are booked around installer availability, as they are in nearby Hythe (3 miles) and Totton (4 miles).

Hampshire covers the port-city shops and offices of Southampton and Portsmouth, Winchester's listed centre, and commuter estates around Basingstoke, Eastleigh and Fareham.

Common uses:

Frameless office partitions and doors
Balustrades in a laminated toughened makeup
Panes below 800 mm in homes and offices
Glazed doors and side panels

What to think about first

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

Heat soaking

Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.

Consents and safety: England

England

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

How it works

Send sizes or use the quote tool
Free survey at your Southampton address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Southampton: questions

Can you survey in Southampton and nearby towns?

Yes. Surveys in Southampton, Hythe and Totton are booked around installer availability.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

Toughened safety glass in nearby towns

Other glazing in Southampton

Ready for a price? Use the form or call 0800 088 6248.