How much should I budget for toughened safety glass in Greater Manchester?
Typical prices for toughened safety glass in Greater Manchester are £114 to £414 including VAT (£95 to £345 plus VAT) per pane, supplied and fitted. Use the quote tool for a guide figure, then we survey and confirm a fixed price.
Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.
Specification at a glance
- Four to five times the strength of annealed glass
- Made to BS EN 12150 and marked for identification
- Single panes or the outer pane of a sealed unit
- Holes, notches and polished edges for frameless fittings
- Breaks into small blunt fragments
- Made to measure for each opening
Covering Greater Manchester
We can arrange surveys and fitting anywhere in Greater Manchester, including Manchester and Oldham. Dates depend on installer availability. Choose your town below for local details.
Greater Manchester mixes city-centre offices and converted mills with Victorian terraces in Salford, Oldham and Bolton, suburban high streets and large out-of-town retail parks.
Common uses:
- Shower screens and splashbacks
- Glazed doors and side panels
- Frameless office partitions and doors
- Balustrades in a laminated toughened makeup
Towns in Greater Manchester
- AltrinchamWA14
- Ashton-in-MakerfieldWN4
- Ashton-under-LyneOL7
- AthertonM46
- BoltonBL1
- BuryBL9
- ChaddertonOL9
- Cheadle HulmeSK8
- DentonM34
- DroylsdenM43
- DukinfieldSK16
- EcclesM30
- FailsworthM35
- FarnworthBL4
- GolborneWA3
- Hazel GroveSK7
- HeywoodOL10
- HindleyWN2
- HydeSK14
- LeighWN7
- ManchesterM1
- MiddletonM24
- OldhamOL1
- PrestwichM25
- RadcliffeM26
- RochdaleOL16
- RoytonOL2
- SaddleworthOL3
- SaleM33
- SalfordM6
- StalybridgeSK15
- StockportSK1
- StretfordM32
- SwintonM27
- TyldesleyM29
- UrmstonM41
- WalkdenM28
- WesthoughtonBL5
- WhitefieldM45
- WiganWN1
What to think about first
Measure once, carefully
Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.
Heat soaking
Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.
Consents and safety: England
Safety glass in critical locations
In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.
Glazing in workplaces
Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.
How it works
- Postcode and a few photos
- On-site survey
- Fixed written price and lead time
- Fit, check and explain
Toughened safety glass in Greater Manchester: questions
Which towns in Greater Manchester do you cover?
We can arrange work anywhere in Greater Manchester, including Manchester, Oldham, Wigan, Bolton and Stockport, and in other towns across the area.
Why did my toughened glass break on its own?
Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.
Where must safety glass be used?
In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.
How can I tell if glass is toughened?
Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.
Other glazing in Greater Manchester
- Security double-glazed units
- Security secondary glazing
- Security window film
- Misted unit replacement with laminated glass
- Counter and reception security screens
- Patio and bifold door security glass
Start with a guide price online, then we survey and fix the price in writing.
