Toughened safety glass in Whitefield

Toughened safety glass in Whitefield: what will it cost?

Budget £114 to £414 including VAT (£95 to £345 plus VAT) per pane for toughened safety glass in Whitefield, supplied and fitted. Larger panes, thicker makeups and difficult access cost more; the price is fixed in writing after the survey.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What goes into toughened safety glass

Four to five times the strength of annealed glass
Made to measure for each opening
Breaks into small blunt fragments
Heat-soaked option for large and overhead panes
Made to BS EN 12150 and marked for identification
Single panes or the outer pane of a sealed unit

Fitting in Whitefield and nearby

Surveys in Whitefield (M45) are booked around installer availability. We also cover nearby Radcliffe (1 mile), Prestwich (1 mile) and Bury (3 miles).

Greater Manchester mixes city-centre offices and converted mills with Victorian terraces in Salford, Oldham and Bolton, suburban high streets and large out-of-town retail parks.

Typical settings for toughened safety glass:

Panes below 800 mm in homes and offices
Balustrades in a laminated toughened makeup
Frameless office partitions and doors
Glazed doors and side panels

Getting the right glass for your building

Heat soaking

Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

What the rules say in England

England

Fire-rated glass is different

Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

How it works

Guide price online or by phone
Survey in Whitefield
Accept the fixed quote
Fitted by glaziers working under our contract

Toughened safety glass in Whitefield: questions

Can you survey in Whitefield and nearby towns?

Yes. Surveys in Whitefield, Radcliffe and Prestwich are booked around installer availability.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

Toughened safety glass in nearby towns

Other glazing in Whitefield

Tell us about the glazing and we will come back with a guide price.