Toughened safety glass in Holloway

How much does toughened safety glass cost in Holloway?

Guide prices for toughened safety glass in Holloway are £114 to £414 including VAT (£95 to £345 plus VAT) per pane for supply and fitting. We confirm a fixed price in writing after a free survey, before any glass is ordered.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What goes into toughened safety glass

Four to five times the strength of annealed glass
Made to BS EN 12150 and marked for identification
Breaks into small blunt fragments
Holes, notches and polished edges for frameless fittings
Heat-soaked option for large and overhead panes
Single panes or the outer pane of a sealed unit

Fitting in Holloway and nearby

Surveys in Holloway (N7) are booked around installer availability. We also cover nearby Highbury (1 mile), Archway (1 mile) and Camden Town (1 mile).

Greater London has every kind of glazing, from Georgian sashes and Victorian bays in conservation areas to high-street shopfronts, office curtain walling and new-build flats.

Typical places for toughened safety glass:

Frameless office partitions and doors
Glazed doors and side panels
Balustrades in a laminated toughened makeup
Shower screens and splashbacks

Things to decide before you order

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

Rules that apply in England

England

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

Replacing glass in an existing frame

Replacing only the glass or sealed unit in an existing frame is generally treated as a repair in England rather than notifiable building work. Replacing a whole window or door is notifiable and is normally certified through a competent person scheme or approved by building control. Either way, new glass in a critical location should still be safety glass.

How it works

Send sizes or use the quote tool
Free survey at your Holloway address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Holloway: questions

Can you survey in Holloway and nearby towns?

Yes. Surveys in Holloway, Highbury and Archway are booked around installer availability.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

Toughened safety glass in nearby towns

Other glazing in Holloway

Ready for a price? Use the form or call 0800 088 6248.