Toughened safety glass in Fulham

Toughened safety glass in Fulham: what will it cost?

As a guide, allow £114 to £414 including VAT (£95 to £345 plus VAT) per pane for toughened safety glass in Fulham, supplied and fitted. Size, glass makeup, access and frame condition move the price, which is confirmed in writing after the free survey.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

Specification at a glance

Heat-soaked option for large and overhead panes
Four to five times the strength of annealed glass
Made to measure for each opening
Clear, tinted, obscure, low-iron and sandblasted finishes
Made to BS EN 12150 and marked for identification
Holes, notches and polished edges for frameless fittings

Fitting in Fulham and nearby

Whether you are in central Fulham or at the edge of the SW6 district, we can arrange a survey. Nearby Chelsea and Putney are covered too.

Greater London has every kind of glazing, from Georgian sashes and Victorian bays in conservation areas to high-street shopfronts, office curtain walling and new-build flats.

Typical settings for toughened safety glass:

Balustrades in a laminated toughened makeup
Shower screens and splashbacks
Glazed doors and side panels
Frameless office partitions and doors

Getting the right glass for your building

Barriers and balustrades

Glass that acts as a barrier usually needs a laminated toughened makeup so it stays in place if one ply breaks.

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

What the rules say in England

England

Fire-rated glass is different

Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

How it works

Postcode and a few photos
On-site survey
Fixed written price and lead time
Fit, check and explain

Toughened safety glass in Fulham: questions

Do you cover Chelsea as well as Fulham?

Yes. As well as Fulham, we can arrange surveys in nearby Chelsea, Putney and Battersea. Dates depend on installer availability.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Toughened safety glass in nearby towns

Other glazing in Fulham

Start with a guide price online, then we survey and fix the price in writing.