Toughened safety glass in Bournemouth

Toughened safety glass in Bournemouth: what will it cost?

Typical prices for toughened safety glass in Bournemouth are £114 to £414 including VAT (£95 to £345 plus VAT) per pane, supplied and fitted. Use the quote tool for a guide figure, then we survey and confirm a fixed price.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

Glass and fitting options

Holes, notches and polished edges for frameless fittings
Made to BS EN 12150 and marked for identification
Clear, tinted, obscure, low-iron and sandblasted finishes
Single panes or the outer pane of a sealed unit
Breaks into small blunt fragments
Made to measure for each opening

Fitting in Bournemouth and nearby

Surveys in Bournemouth (BH1) are booked around installer availability, as they are in nearby Christchurch (4 miles) and Poole (5 miles).

Dorset covers Bournemouth and Poole's seafront hotels, offices and shopping streets, Georgian fronts in Weymouth, and stone market towns such as Dorchester, Bridport and Sherborne.

Typical settings for toughened safety glass:

Shower screens and splashbacks
Balustrades in a laminated toughened makeup
Glazed doors and side panels
Frameless office partitions and doors

Getting the right glass for your building

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Heat soaking

Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.

What the rules say in England

England

Replacing glass in an existing frame

Replacing only the glass or sealed unit in an existing frame is generally treated as a repair in England rather than notifiable building work. Replacing a whole window or door is notifiable and is normally certified through a competent person scheme or approved by building control. Either way, new glass in a critical location should still be safety glass.

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

How it works

Postcode and a few photos
On-site survey
Fixed written price and lead time
Fit, check and explain

Toughened safety glass in Bournemouth: questions

Can you survey in Bournemouth and nearby towns?

Yes. Surveys in Bournemouth, Christchurch and Poole are booked around installer availability.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Is toughened glass a security glass?

No. Toughened glass is strong and breaks safely, but once broken the pane falls out and leaves the opening clear. For security, choose laminated glass or a unit with a laminated pane.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Toughened safety glass in nearby towns

Other glazing in Bournemouth

Start with a guide price online, then we survey and fix the price in writing.