Toughened safety glass in West Midlands

What should toughened safety glass cost in West Midlands?

Our guide range for toughened safety glass in West Midlands is £114 to £414 including VAT (£95 to £345 plus VAT) per pane, including fitting. The survey is free for new installations and your fixed price follows in writing.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What goes into toughened safety glass

Made to BS EN 12150 and marked for identification
Single panes or the outer pane of a sealed unit
Breaks into small blunt fragments
Four to five times the strength of annealed glass
Clear, tinted, obscure, low-iron and sandblasted finishes
Made to measure for each opening

Covering West Midlands

We can arrange surveys and fitting anywhere in West Midlands, including Birmingham and Coventry. Dates depend on installer availability. Choose your town below for local details.

The West Midlands spans Birmingham's city-centre offices and shopping streets, Coventry's post-war precincts, Black Country terraces and long suburban high streets in Wolverhampton and Dudley.

Good candidates for toughened safety glass:

Panes below 800 mm in homes and offices
Glazed doors and side panels
Frameless office partitions and doors
Shower screens and splashbacks

Towns in West Midlands

Before the glass is ordered

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Barriers and balustrades

Glass that acts as a barrier usually needs a laminated toughened makeup so it stays in place if one ply breaks.

Glazing rules in England

England

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

Fire-rated glass is different

Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.

How it works

Send sizes or use the quote tool
Free survey at your West Midlands address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in West Midlands: questions

Which towns in West Midlands do you cover?

We can arrange work anywhere in West Midlands, including Birmingham, Coventry, Wolverhampton, Dudley and Walsall, and in other towns across the area.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Is toughened glass a security glass?

No. Toughened glass is strong and breaks safely, but once broken the pane falls out and leaves the opening clear. For security, choose laminated glass or a unit with a laminated pane.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Other glazing in West Midlands

Ready for a price? Use the form or call 0800 088 6248.