How much should I budget for toughened safety glass in Reigate?
Budget £114 to £414 including VAT (£95 to £345 plus VAT) per pane for toughened safety glass in Reigate, supplied and fitted. Larger panes, thicker makeups and difficult access cost more; the price is fixed in writing after the survey.
Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.
What goes into toughened safety glass
- Breaks into small blunt fragments
- Single panes or the outer pane of a sealed unit
- Heat-soaked option for large and overhead panes
- Four to five times the strength of annealed glass
- Made to measure for each opening
- Holes, notches and polished edges for frameless fittings
Fitting in Reigate and nearby
Surveys in Reigate (RH2) are booked around installer availability. We also cover nearby Redhill (2 miles), Horley (5 miles) and Banstead (6 miles).
Surrey's commuter towns such as Guildford, Woking and Epsom mix Victorian and inter-war houses with modern glazed offices, while Farnham and Godalming have extensive conservation areas.
Common uses:
- Glazed doors and side panels
- Panes below 800 mm in homes and offices
- Shower screens and splashbacks
- Frameless office partitions and doors
What to think about first
Barriers and balustrades
Glass that acts as a barrier usually needs a laminated toughened makeup so it stays in place if one ply breaks.
Toughened or laminated
Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.
Consents and safety: England
Glazing in workplaces
Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.
Safety glass in critical locations
In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.
How it works
- Send sizes or use the quote tool
- Free survey at your Reigate address
- Fixed price in writing
- Glass made, then fitted
Toughened safety glass in Reigate: questions
Can you survey in Reigate and nearby towns?
Yes. Surveys in Reigate, Redhill and Horley are booked around installer availability.
Can toughened glass be cut to fit?
No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.
Is toughened glass a security glass?
No. Toughened glass is strong and breaks safely, but once broken the pane falls out and leaves the opening clear. For security, choose laminated glass or a unit with a laminated pane.
How can I tell if glass is toughened?
Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.
Toughened safety glass in nearby towns
Other glazing in Reigate
- Glazing bead security upgrades
- Anti-ram-raid glazing
- Laminated glass retrofit
- Laminated security glass
- Security glazed doors and screens
- Bullet-resistant glass
Ready for a price? Use the form or call 0800 088 6248.