Toughened safety glass in Cheshunt

What is the price of toughened safety glass in Cheshunt?

As a guide, allow £114 to £414 including VAT (£95 to £345 plus VAT) per pane for toughened safety glass in Cheshunt, supplied and fitted. Size, glass makeup, access and frame condition move the price, which is confirmed in writing after the free survey.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

Choices you can make

Four to five times the strength of annealed glass
Clear, tinted, obscure, low-iron and sandblasted finishes
Breaks into small blunt fragments
Holes, notches and polished edges for frameless fittings
Made to BS EN 12150 and marked for identification
Single panes or the outer pane of a sealed unit

Fitting in Cheshunt and nearby

We can arrange toughened safety glass anywhere in Cheshunt, and in nearby Waltham Abbey, Enfield and Hoddesdon. Tell us your postcode and we will offer dates.

Hertfordshire includes the historic centres of St Albans and Hertford, post-war new towns such as Stevenage and Hatfield, and Watford's shops and office parks along the M1.

This glazing suits:

Frameless office partitions and doors
Shower screens and splashbacks
Glazed doors and side panels
Balustrades in a laminated toughened makeup

Questions we will ask at the survey

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Heat soaking

Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.

Building regulations and safety in England

England

Replacing glass in an existing frame

Replacing only the glass or sealed unit in an existing frame is generally treated as a repair in England rather than notifiable building work. Replacing a whole window or door is notifiable and is normally certified through a competent person scheme or approved by building control. Either way, new glass in a critical location should still be safety glass.

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

How it works

Send sizes or use the quote tool
Free survey at your Cheshunt address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Cheshunt: questions

Which areas near Cheshunt do you cover?

We can arrange work in Cheshunt and in nearby Waltham Abbey (1 mile), Enfield (4 miles) and Hoddesdon (4 miles). Dates depend on installer availability.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

Toughened safety glass in nearby towns

Other glazing in Cheshunt

Ready for a price? Use the form or call 0800 088 6248.