Toughened safety glass in Worcestershire

Toughened safety glass in Worcestershire: what will it cost?

Our guide range for toughened safety glass in Worcestershire is £114 to £414 including VAT (£95 to £345 plus VAT) per pane, including fitting. The survey is free for new installations and your fixed price follows in writing.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

Specification at a glance

Made to BS EN 12150 and marked for identification
Clear, tinted, obscure, low-iron and sandblasted finishes
Four to five times the strength of annealed glass
Breaks into small blunt fragments
Single panes or the outer pane of a sealed unit
Heat-soaked option for large and overhead panes

Covering Worcestershire

We can arrange surveys and fitting anywhere in Worcestershire, including Worcester and Redditch. Dates depend on installer availability. Choose your town below for local details.

Worcestershire includes Worcester's cathedral-city centre, Georgian streets in Bewdley and Pershore, Malvern's Victorian villas, and newer estates around Redditch and Bromsgrove.

Typical settings for toughened safety glass:

Panes below 800 mm in homes and offices
Frameless office partitions and doors
Balustrades in a laminated toughened makeup
Shower screens and splashbacks

Towns in Worcestershire

Getting the right glass for your building

Barriers and balustrades

Glass that acts as a barrier usually needs a laminated toughened makeup so it stays in place if one ply breaks.

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

What the rules say in England

England

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

Fire-rated glass is different

Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.

How it works

Postcode and a few photos
On-site survey
Fixed written price and lead time
Fit, check and explain

Toughened safety glass in Worcestershire: questions

Which towns in Worcestershire do you cover?

We can arrange work anywhere in Worcestershire, including Worcester, Redditch, Kidderminster, Malvern and Bromsgrove, and in other towns across the area.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

Other glazing in Worcestershire

Start with a guide price online, then we survey and fix the price in writing.