Toughened safety glass in Huddersfield

Toughened safety glass in Huddersfield: what will it cost?

Our guide range for toughened safety glass in Huddersfield is £114 to £414 including VAT (£95 to £345 plus VAT) per pane, including fitting. The survey is free for new installations and your fixed price follows in writing.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What goes into toughened safety glass

Holes, notches and polished edges for frameless fittings
Four to five times the strength of annealed glass
Heat-soaked option for large and overhead panes
Clear, tinted, obscure, low-iron and sandblasted finishes
Made to BS EN 12150 and marked for identification
Breaks into small blunt fragments

Fitting in Huddersfield and nearby

Surveys in Huddersfield (HD1) are booked around installer availability. We also cover nearby Brighouse (4 miles), Halifax (5 miles) and Cleckheaton (6 miles).

West Yorkshire mixes the offices and Victorian arcades of Leeds with stone terraces and mill buildings in Bradford, Halifax and Huddersfield, and Wakefield's town-centre retail.

Typical settings for toughened safety glass:

Shower screens and splashbacks
Balustrades in a laminated toughened makeup
Glazed doors and side panels
Frameless office partitions and doors

Getting the right glass for your building

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

What the rules say in England

England

Fire-rated glass is different

Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

How it works

Send sizes or use the quote tool
Free survey at your Huddersfield address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Huddersfield: questions

Can you survey in Huddersfield and nearby towns?

Yes. Surveys in Huddersfield, Brighouse and Halifax are booked around installer availability.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Toughened safety glass in nearby towns

Other glazing in Huddersfield

Ready for a price? Use the form or call 0800 088 6248.