Toughened safety glass in Stafford

Toughened safety glass in Stafford: what will it cost?

Expect £114 to £414 including VAT (£95 to £345 plus VAT) per pane for toughened safety glass in Stafford. The written quote names the glass makeup, the price and the lead time before you commit.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

Choices you can make

Breaks into small blunt fragments
Four to five times the strength of annealed glass
Made to measure for each opening
Holes, notches and polished edges for frameless fittings
Single panes or the outer pane of a sealed unit
Made to BS EN 12150 and marked for identification

Fitting in Stafford and nearby

We can arrange toughened safety glass anywhere in Stafford, and in nearby Rugeley, Cannock and Burntwood. Tell us your postcode and we will offer dates.

Staffordshire mixes Stoke-on-Trent's Victorian pottery-town terraces with Lichfield's cathedral quarter, Burton's brewery streets and newer estates around Tamworth and Cannock.

Typical settings for toughened safety glass:

Frameless office partitions and doors
Panes below 800 mm in homes and offices
Shower screens and splashbacks
Balustrades in a laminated toughened makeup

Getting the right glass for your building

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

What the rules say in England

England

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

Fire-rated glass is different

Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.

How it works

Send sizes or use the quote tool
Free survey at your Stafford address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Stafford: questions

Which areas near Stafford do you cover?

We can arrange work in Stafford and in nearby Rugeley (8 miles), Cannock (9 miles) and Burntwood (12 miles). Dates depend on installer availability.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

Toughened safety glass in nearby towns

Other glazing in Stafford

Ready for a price? Use the form or call 0800 088 6248.