Toughened safety glass in Mid Glamorgan

Toughened safety glass in Mid Glamorgan: what will it cost?

Our guide range for toughened safety glass in Mid Glamorgan is £114 to £414 including VAT (£95 to £345 plus VAT) per pane, including fitting. The survey is free for new installations and your fixed price follows in writing.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

What you can specify

Breaks into small blunt fragments
Single panes or the outer pane of a sealed unit
Made to BS EN 12150 and marked for identification
Four to five times the strength of annealed glass
Clear, tinted, obscure, low-iron and sandblasted finishes
Holes, notches and polished edges for frameless fittings

Covering Mid Glamorgan

We can arrange surveys and fitting anywhere in Mid Glamorgan, including Rhondda and Tonypandy. Dates depend on installer availability. Choose your town below for local details.

Mid Glamorgan covers the valley towns of Merthyr Tydfil, Pontypridd and Aberdare with their long terraced streets, Bridgend's town centre and retail parks, and newer estates near the M4.

Typical settings for toughened safety glass:

Balustrades in a laminated toughened makeup
Panes below 800 mm in homes and offices
Frameless office partitions and doors
Glazed doors and side panels

Towns in Mid Glamorgan

Getting the right glass for your building

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Toughened or laminated

Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.

What the rules say in Wales

Wales

Replacing glass in an existing frame

Welsh Government guidance says building regulations have applied to replacement glazing since 1 April 2002, which covers replacing windows and doors. Swapping only the glass or a sealed unit in an existing frame is generally treated as a repair. New glass in a critical location should still be safety glass, and the council's building control team can confirm anything unclear.

Safety glass in critical locations

In Wales, safety glazing is covered by Approved Document N (glazing) under the Welsh Building Regulations rather than Approved Document K. Glass in doors up to 1,500 mm above the floor, in panes within 300 mm of a door up to 1,500 mm, and in other glazing below 800 mm should be safety glass or protected. Laminated and toughened glass are the usual choices.

How it works

Send sizes or use the quote tool
Free survey at your Mid Glamorgan address
Fixed price in writing
Glass made, then fitted

Toughened safety glass in Mid Glamorgan: questions

Which towns in Mid Glamorgan do you cover?

We can arrange work anywhere in Mid Glamorgan, including Rhondda, Tonypandy, Bridgend, Merthyr Tydfil and Pontypridd, and in other towns across the area.

Can toughened glass be cut to fit?

No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Where must safety glass be used?

In critical locations: in England, Approved Document K covers glazing in and beside doors up to 1,500 mm from the floor and other glazing below 800 mm; Wales has the same idea in its Approved Document N, Scotland in standard 4.8 and Northern Ireland in Part V. Glass there must be safety glass or protected.

Other glazing in Mid Glamorgan

Ready for a price? Use the form or call 0800 088 6248.