Toughened safety glass in Strood: what will it cost?
Guide prices for toughened safety glass in Strood are £114 to £414 including VAT (£95 to £345 plus VAT) per pane for supply and fitting. We confirm a fixed price in writing after a free survey, before any glass is ordered.
Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.
Specification at a glance
- Clear, tinted, obscure, low-iron and sandblasted finishes
- Made to BS EN 12150 and marked for identification
- Made to measure for each opening
- Breaks into small blunt fragments
- Holes, notches and polished edges for frameless fittings
- Four to five times the strength of annealed glass
Fitting in Strood and nearby
Whether you are in central Strood or at the edge of the ME2 district, we can arrange a survey. Nearby Rochester and Chatham are covered too.
Kent ranges from Canterbury's listed city centre and the Regency fronts of Tunbridge Wells to the Medway towns, Ashford's growth estates and coastal Margate and Folkestone.
Typical settings for toughened safety glass:
- Shower screens and splashbacks
- Panes below 800 mm in homes and offices
- Glazed doors and side panels
- Frameless office partitions and doors
Getting the right glass for your building
Heat soaking
Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.
Toughened or laminated
Toughened gives strength and safe breakage. Laminated gives safe breakage and stays in place, which is what security needs. Many doors use both in one sealed unit.
What the rules say in England
Safety glass in critical locations
In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.
Fire-rated glass is different
Glass in fire doors, fire screens and protected escape routes has to be fire-rated glass tested as part of that door or screen system, under Approved Document B and the fire safety duties of the building's responsible person. Laminated and security glass are not fire-rated unless the product says so. Where a pane needs both fire and security performance, it must be a product tested for both.
How it works
- Postcode and a few photos
- On-site survey
- Fixed written price and lead time
- Fit, check and explain
Toughened safety glass in Strood: questions
Do you cover Rochester as well as Strood?
Yes. As well as Strood, we can arrange surveys in nearby Rochester, Chatham and Gillingham. Dates depend on installer availability.
Can toughened glass be cut to fit?
No. Cutting or drilling toughened glass makes it shatter, so every pane, hole and notch is made to size before toughening.
Why did my toughened glass break on its own?
Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.
How can I tell if glass is toughened?
Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.
Toughened safety glass in nearby towns
Other glazing in Strood
- Laminated roof and conservatory glass
- Security secondary glazing
- Laminated security glass
- Misted unit replacement with laminated glass
- Display case security glass
- Security glazed doors and screens
Start with a guide price online, then we survey and fix the price in writing.