Toughened safety glass in Sandown

How much does toughened safety glass cost in Sandown?

As a guide, toughened safety glass costs £114 to £414 including VAT (£95 to £345 plus VAT) per pane. Because work in Sandown is arranged individually, we confirm the full price, including any travel, in writing first.

Toughened safety glass is ordinary glass that has been heated and rapidly cooled so its surface is held in compression, making it four to five times stronger than annealed glass of the same thickness. If it does break, it shatters into small, relatively blunt pieces instead of sharp shards, which is why it is used in doors, low-level panes and frameless partitions.

Specification at a glance

Single panes or the outer pane of a sealed unit
Made to measure for each opening
Holes, notches and polished edges for frameless fittings
Made to BS EN 12150 and marked for identification
Clear, tinted, obscure, low-iron and sandblasted finishes
Four to five times the strength of annealed glass

Fitting in Sandown

Surveys and fitting in Sandown are arranged case by case because of travel and glass delivery. Tell us about the job and we will come back with options.

The Isle of Wight's Victorian seaside towns such as Ryde, Sandown and Ventnor sit alongside Newport's shopping streets and Cowes' waterfront, with every glass delivery crossing by ferry.

Typical places for toughened safety glass:

Glazed doors and side panels
Frameless office partitions and doors
Panes below 800 mm in homes and offices
Shower screens and splashbacks

Things to decide before you order

Measure once, carefully

Toughened glass cannot be cut afterwards, so holes and sizes are fixed at the factory. Accurate survey measurements avoid remakes.

Heat soaking

Rare nickel sulphide inclusions can make toughened glass break without warning. Heat soaking reduces the risk and is worth specifying for large, high or overhead panes.

Rules that apply in England

England

Safety glass in critical locations

In England, section 5 of Approved Document K treats glazing in doors and in side panels within 300 mm of a door edge, from floor level up to 1,500 mm, and any other glazing below 800 mm, as a critical location. Glass there should break safely, be robust, or be guarded. Laminated or toughened glass meeting BS EN 12600 class 3 is the usual answer, rising to class 2 for door and side-panel panes wider than 900 mm.

Glazing in workplaces

Regulation 14 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires windows and transparent surfaces in walls, partitions, doors and gates to be of safety material or protected against breakage where health or safety makes that necessary, and to be marked so people notice them. The employer or the person in control of the premises decides what is needed through their risk assessment.

How it works

Send sizes, photos and your postcode
We confirm what is possible and when
Fixed price in writing
Glass made, delivered and fitted

Toughened safety glass in Sandown: questions

Can you work in Sandown?

Work in Sandown is arranged individually because of travel. Send your postcode and details and we will confirm what is possible.

How can I tell if glass is toughened?

Look for a permanent mark etched in a corner naming the standard. Polarised sunglasses can also show faint patterns in toughened glass. We can check during the survey.

Why did my toughened glass break on its own?

Occasionally a tiny nickel sulphide inclusion or edge damage causes spontaneous breakage. Heat-soak tested glass reduces the risk for large or high panes.

Is toughened glass a security glass?

No. Toughened glass is strong and breaks safely, but once broken the pane falls out and leaves the opening clear. For security, choose laminated glass or a unit with a laminated pane.

Toughened safety glass in nearby towns

Other glazing in Sandown

Send sizes and photos with the form, or call 0800 088 6248.